On good days, it would stay on for a few hours during turnout. I tried using it by putting a bit of cotton wool with the gel over the toe crack, then taping it on with duct tape. ![]() You're supposed to apply it to some cotton wool or similar and then seal off the area to allow the fumes to do their thing. I'm honestly not sure how much good it did, but it works by creating fumes/gas that disinfects. IME, the only way to get on top of it is to either dry it out (air) or treat daily, and it's just impossible to get proper treatment down a narrow, deep crack.Īnother treatment I've tried is White Lightning Gel (different horse with toe crack, not yet full-blown WLD/seedy toe, and more as prevention). If there's a place/pocket where the WLD travels up quite a bit and where the crack is very narrow, I'd consider talking to your farrier about opening that area up to expose it to air. Or just leave without treatment, hoping enough air will get to it after cleaning before it gets packed with moist dirt again. If the WLD is superficial around most of the hoof, or the gap is pretty wide, I'd probably leave it and try cleaning it out daily (wire brush can be good to get caked dirt out of grooves) and then spray/pack with something antiseptic (Miltons, Red horse sole cleanse spray or ArtiMud, anything else you feel like trying). a thin piece of stiff wire that isn't pointy) to feel how deep it goes. using a paper clip that you've bent open (e.g. I think I'd investigate how deep the WLD goes e.g. I think the problem is that even if the CleanTrax does its job perfectly, you are still left with a narrow, moist crack and new bacteria will quickly settle in again. In the end, the only way to conquer it was to open up the crack enough to allow air in there. ![]() I do have experience dealing with a stubborn case of WLD/seedy toe though which started at/behind a toe crack and kept eating up the white line as quickly as it would grow down. When you use CRC throttle cleaner, your engine gets a new lease of life.Never used Cleantrax myself, so can't advise on how effective it is. The CRC throttle cleaner works quickly as soon as it is sprayed on and removes blockages from the pipes leading to the combustion chamber. Most professional mechanics also use this cleaner and prefer it to others. They produce first-class throttle body cleaners, so there is no doubt about the performance of their products. The brand name CRC is very popular among car enthusiasts. The one I recommend is the CRC Throttle body cleaner, which you can find on Amazon. There are many throttle cleaners on the market, so it is difficult to distinguish a good one from a bad one. If you drop something in the intake manifold and can’t remove it, you need to remove the intake manifold and remove the object before trying to start the engine. You may also want to let the vehicle sit for a couple of hours afterward to make sure the throttle body cleaner dries up. The trick to cleaning a throttle body without removing it is to not spray too much cleaner and to be very careful not to drop anything into the intake. However, be very careful not to drop the cloth into the intake manifold. Open the throttle body valve with a screwdriver and gently spray the throttle body cleaner and remove dirt with a cloth. If you want to clean the throttle body without removing it, the process is almost the same, but you have to be more careful. How Do You Clean The Throttle Body Without Removing it? ![]() If everything seems fine, you have successfully completed a throttle body cleaning and saved some money! Take your car for a test drive and look for any signs of a problem or warning lights on your dashboard. Once the throttle body is calibrated, you should clear the trouble codes if you have a diagnostic scanner.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |